GREPhysics.NET: GR0177 #85

GR0177 #85

Problem

GREPhysics.NET Official Solution

This problem is still being typed.

Electromagnetism $\Rightarrow$ }Resistivity

This is a baby circuits problem once one calculates the net resistance.

Recall that resistance is related to length and area by $R=\rho l/a$ .

Thus, the resistance of the thin and long wire is $R_{tl}=\rho 2L/A$ , while the resistance of the fat and short wire is $R_{fs}=\rho L/(2A)$ .

The resistors are in series, and so the equivalent resistance is $R_{eq} = \rho L/A(2+1/2)=5\rho L/(2A)$ .

Plug that into Ohm's Law to find the current $\Delta V = I R_{tot} = 8-1=7$ . Thus, $I=14A/(5\rho L)$ .

To find the potential at the junction, use Ohm's Law again to get $V_{junction}=1+IR_{fs}$ . Chunking out the algebraic expressions, one gets 2.4 V, as in choice (A0.

Alternate Solutions

BerkeleyEric 2010-10-03 11:38:34	Since the resistance is directly proportional to the length and inversely proportional to the area, we know that the longer wire is four times as resistant as the shorter one. This means that the voltage drop is four times as much for the longer wire, so it is $\frac{4}{5}\ \left(7\ V\right)$ . Subtracting this from 8.0 V gives the answer, (A). Reply to this comment
BerkeleyEric 2010-10-03 11:38:02	Since the resistance is directly proportional to the length and inversely proportional to the area, we know that the longer wire is four times as resistant as the shorter one. This means that the voltage drop is four times as much for the longer wire, so it is $\frac{4}{5}\ \left(7\ V\right)$ . Subtracting this from 8.0 V gives the answer, (A). Reply to this comment
94709 2007-10-29 23:04:05	You can calculate current although one doesn't have to. This is just a voltage divider. $R_1=\rho\frac{2L}{A}$ , $R_2=\rho\frac{L}{2A}$ , $\Delta V=7$ Volts. Therefore, $V=7\times\frac{\rho}{\rho}\times\frac{\frac{L}{2A}}{\frac{2L}{A}+\frac{L}{2A}}=\frac{7}{5}=1.4$ Since the base is $1$ V, the potential at the dividing segment is 2.4V. Reply to this comment

Comments

Dudeleb
2016-10-27 15:16:34

here is a fun little rhyme to help you remember the resistance of a wire. Resistance = RHO RHO RHO YOUR BOAT L OVER A! RESISTANCE RESISTANCE RESISTANCE LIFE IS BUT A DREAM (of an electron traveling down some conducting material). The rest is math. Plug and chug. Like a beer. Am I RIGHT!? Ah man. This test is making me crazy. Cheers all.

Reply to this comment

ChildAtPlay
2012-04-16 04:14:14

R = rho * L / A. Rho is the same for both wires.
Setting L = 1, A = 1:

Wire 1: R1 = 2L/A = 2

Wire 2: R2 = L/2A = 1/2

Rtotal = R1 + R2 = 2.5.

deltaV for wire 2 is R2/Rtotal = 0.5/2.5 = 0.2.

The voltage drop across wire 2 is 20% of the total voltage drop (Kirchoff).

Voltage @ junction = 1V + 0.2 * (8V-7V) = 1V + 1.4V = 2.4V.

Reply to this comment

BerkeleyEric
2010-10-03 11:38:34

Since the resistance is directly proportional to the length and inversely proportional to the area, we know that the longer wire is four times as resistant as the shorter one. This means that the voltage drop is four times as much for the longer wire, so it is $\frac{4}{5}\ \left(7\ V\right)$ . Subtracting this from 8.0 V gives the answer, (A).

Reply to this comment

BerkeleyEric
2010-10-03 11:38:02

Reply to this comment

grae313
2007-11-01 10:17:36

Alternately, (and this is essentially equivalent 94709's solution, but involves simpler calculations, IMO), once you have the two resistances for the two wires, you can realize that $R_1 = 4R_2$ which means that the ratio of the voltage drops in each wire segment has to be 1:4, or:

$\frac{\Delta V_1}{\Delta V_2} = \frac{4}{1}$ and also

$\Delta V_1 + \Delta V_2 = 7$

easy math to arrive at the answer.

grae313
2007-11-01 10:17:59

ack, I meant to classify this as an alternate solution

Reply to this comment

94709
2007-10-29 23:04:05

You can calculate current although one doesn't have to. This is just a voltage divider.

$R_1=\rho\frac{2L}{A}$ , $R_2=\rho\frac{L}{2A}$ , $\Delta V=7$ Volts.

Therefore,

$V=7\times\frac{\rho}{\rho}\times\frac{\frac{L}{2A}}{\frac{2L}{A}+\frac{L}{2A}}=\frac{7}{5}=1.4$

Since the base is $1$ V, the potential at the dividing segment is 2.4V.

94709
2007-10-29 23:14:15

eh, you might not be checking this site any more, but thanks a lot, yosun.

Reply to this comment

keflavich
2005-11-10 22:38:30

There are a few typos here. $I=\frac{14A}{5(pL)}$ , you left out the 5. That 0 at the end should be a ')'.

But also... where does the 1 come from in $V=1+IR_{fs}$ ?

yosun
2005-11-10 22:49:04

keflavich: thanks for the typo alert; the typo has been corrected.

the 1 comes from the fact that the potential at the end of the fatter wire is 1V, and thus the voltage across the junction is just the voltage at the end of the fat wire plus the current times the resistance of the fatter wire. (i tend to leave off the units to avoid confusion with variables)

Richard
2007-10-29 10:07:52

A perhaps conceptually easier approach would be to simply find the potential difference across the first wire, and then subtract it from the potential at the end of the thin wire. In my view, this is consistent with how you went about finding the current...

$8-(\frac{2\times 14}{5})=2.4$

jmason86
2009-07-09 23:54:25

Alternatively, you could have done $\delta v=IR$ $\Rightarrow$ $1-8 = ...$ yielding the same value for I, but negative.
Then following along Yosun's line (where he implied $V=V_2 + IR_2$ ), we now have instead, $V=V_1 + IR_1$ where I is now negative. Plug in to get $8-\frac{28}{5} = \frac{12}{5}$

I was kind of confused by the above response that Yosun gave using the fatter wire for everything... so I decided to try flipping it around to make sure it still works... and it does :)

Cheers

Reply to this comment

Post A Comment!

You are replying to:

You can calculate current although one doesn't have to. This is just a voltage divider. $R_1=\rho\frac{2L}{A}$ , $R_2=\rho\frac{L}{2A}$ , $\Delta V=7$ Volts. Therefore, $V=7\times\frac{\rho}{\rho}\times\frac{\frac{L}{2A}}{\frac{2L}{A}+\frac{L}{2A}}=\frac{7}{5}=1.4$ Since the base is $1$ V, the potential at the dividing segment is 2.4V.

Bare Basic LaTeX Rosetta Stone
LaTeX syntax supported through dollar sign wrappers $, ex., $\alpha^2_0$ produces $\alpha^2_0$ .
type this...	to get...
$\int_0^\infty$	$\int_0^\infty$
$\partial$	$\partial$
$\Rightarrow$	$\Rightarrow$
$\ddot{x},\dot{x}$	$\ddot{x},\dot{x}$
$\sqrt{z}$	$\sqrt{z}$
$\langle my \rangle$	$\langle my \rangle$
$\left( abacadabra \right)_{me}$	$\left( abacadabra \right)_{me}$
$\vec{E}$	$\vec{E}$
$\frac{a}{b}$	$\frac{a}{b}$

The Sidebar Chatbox...
Scroll to see it, or resize your browser to ignore it...

All-Solutions List | Latest Comments | Unanswered Questions (Cries for Help!) |::| About

This site is not affiliated with ETS, nor is it officially endorsed (yet) by ETS. This site is the work of an individual named Yosun Chang. The solutions, sans user comments and ETS questions, are © 2005 by Yosun Chang except where noted. All rights reserved. / The comments appending particular solutions are due to the respective users. / Educational Testing Service, ETS, the ETS logo, Graduate Record Examinations, and GRE are registered trademarks of Educational Testing Service. The examination questions are © 1997 and © 2001 by ETS.

Bare Basic LaTeX Rosetta Stone